Sacramento Barn Builders logo
Old wood barn with a dark metal roof in dry golden grass, oak trees and foothills behind

Pole Barns · Placerville, CA

Pole Barn Builders in Placerville, CA

Pole Barns for Placerville and El Dorado County. Call or fill out the form for a free quote.

Placerville, El Dorado County and every town within 75 miles of Cameron Park, CA

Get a Free Pole Barn Quote in Placerville

Free quotes. Fill out the form or call, and we'll get right back to you.

  • Free quotes
  • No obligation
  • Local builder
  • 75-mile service area

Fill out the form below to get your free quote 👇

Rather talk? Call us now: (916) 827-4576

Pole Barns · Placerville

Pole Barns in Placerville

Placerville landowners call us for pole barns for hay, tractors, equipment, RVs and boats. Placerville is about 13 miles northeast of our base in Cameron Park, well inside our 75-mile service area.

Foothill parcels are rarely flat: the work starts with a cut-and-fill pad, drainage around the uphill side and a layout that keeps clear of the oaks. Much of this country sits in a Fire Hazard Severity Zone, so metal roofs, metal siding and ember-resistant vents are part of the plan from the start.

The quote is free: tell us the size, what the building is for and where the property is.

White pole barn at the end of a gravel farm road

What's included

Pole Barns we do in Placerville

  • 01

    Hay barns

    Open-sided or partly enclosed hay barns with the eave height to stack with a loader or bale squeeze, and overhangs that keep rain off the outside of the stack.

  • 02

    Equipment and tractor barns

    Clear bays wide and deep enough for a tractor with its implement attached, a sprayer or a flatbed, with an open front or sliding doors.

  • 03

    RV and boat covers

    Tall open covers with the clearance and bay width for a motorhome, a fifth-wheel or a boat on its trailer, out of the sun that cooks roofs and tires.

  • 04

    Lean-tos

    Lean-tos on one or both sides of a new barn or added to one you already have, for extra hay, firewood, equipment or shade for livestock.

  • 05

    Framed for your site

    Post depth and footing size matched to valley clay or foothill rock, and trusses and purlins spaced for the snow load at your elevation and California's seismic rules.

  • 06

    Metal roof, siding and doors

    A metal roof in a light color to cut summer heat, siding on as many walls as you want, and walk, sliding or roll-up doors where you need them.

El Dorado County, California

Pole Barns around Placerville

We build around Placerville, near Eddy Arboretum, Placerville City Park and Fountain-Tallman Soda Works and out by Placerville Airport and Union Hill, and throughout El Dorado County.

Placerville is the El Dorado County seat, the Gold Rush town once called Hangtown, on US-50. Placerville is about 13 miles northeast of our base in Cameron Park, well inside our 75-mile service area.

Northern California asks different things of a building depending on where it sits: valley heat that bakes a bare metal roof in July, winter fog that condenses under it, wildfire rules across much of the foothills, and snow loads that climb with every thousand feet toward Tahoe. So every building starts with engineered plans for the site's seismic, wind and snow loads, a pad that drains, and insulation and ventilation planned in from day one.

Ideas for your project

Pole Barns: what they can look like

  • Round hay bales stored under an open-sided barn roof
  • Group of metal-sided farm barns in a field

How it works

How your Placerville pole barn job works

  1. 1

    Free site visit and quote

    Tell us what the barn is for, the size you need and where it goes. We look at the ground, slope and access and give you a free quote.

  2. 2

    Drawings and permit

    We draw the barn for your site's snow and seismic loads and pull the county permit, or file for an agricultural exemption where your county allows one.

  3. 3

    Layout and posts

    We level the site, lay out the building, auger the holes and set the posts in concrete, square and plumb.

  4. 4

    Trusses, roof and walls

    Trusses go up next, then purlins and girts, then the roof and as much siding as you asked for, down to the doors and trim.

Questions

Pole Barns in Placerville: FAQs

Do you build pole barns in Placerville, CA?

Yes. Placerville is about 13 miles northeast of our base in Cameron Park, well inside our 75-mile service area. We build pole barns for hay, tractors, equipment, RVs and boats there, and the quote is free.

Do I need a permit for a pole barn in Placerville?

Usually. When one is needed, we pull it from the Placerville or El Dorado County building department, depending on which side of the city limits the property is on with engineered plans and build to whatever the permit and inspections require.

How big should my pole barn be?

Size it to what goes inside plus room to work around it. For hay, start from how much you store and how high you stack it; for equipment, measure the largest machine with its implement on and add space to walk around it; for an RV, check the height to the top of the roof air conditioner. We settle the bay widths and eave height with you during the free site visit.

Can a pole barn be enclosed or added onto later?

Yes, if the frame is designed for it. An open-sided barn can be sided and fitted with doors later, and a lean-to can go along either side, but solid walls catch more wind, so the posts and trusses have to be sized for that from the start. If you think you will close it in someday, tell us at the quote and we frame it for that.

How much does a pole barn cost?

It depends mainly on the footprint, the eave height and how much of it is enclosed. An open-sided hay or equipment barn costs much less than the same size fully sided with doors, and the snow load at your elevation decides how heavy the trusses and purlins have to be. Site work matters too, from leveling a slope to drilling post holes through rock. The quote is free once we know what the barn holds, how big it needs to be and where it stands.

Does a pole barn here need to handle fire, snow or heat?

Yes, and which one matters most depends on where it stands. Valley barns mostly fight heat, so a light metal roof, open sides or vents and good airflow keep hay and equipment cooler. In the foothills, a barn close to the house in a Fire Hazard Severity Zone may have to meet the ignition-resistant rules in Chapter 7A, and metal roofing and siding help, while barns around Pollock Pines, Grass Valley or Truckee are framed for real snow. Keeping hay in its own barn, away from the house, is smart anywhere.

Ready to start your Placerville pole barn project?

Free quotes. Call or fill out the form.